Hello all,
Is it possible in IFS (10) to have the Lot Size of a shop order increase in the event that the reported qty from Shop Floor Workbench exceeds the original Lot Size amount? Often times we over run a coil fed job, which will result in the original Lot Size not matching the actual reported qty (Lot Size - 1000, actual completed qty 1230). Any guidance would be greatly appreciated.
Thank you!
Best answer by Björn Hultgren
If you have the Adjust for Op Deviation Qty enabled and report a quantity higher than lot size on an operation, this will automatically increase the quantity on succeeding operations, and the quantity that is expected to be received from the shop order without increasing the lot size.
+25What do you want to achieve with increasing the lot size? Why not just receiving 1230 instead of 1000?
+25If you have the Adjust for Op Deviation Qty enabled and report a quantity higher than lot size on an operation, this will automatically increase the quantity on succeeding operations, and the quantity that is expected to be received from the shop order without increasing the lot size.
+25Yes you can setup the default value per Inventory Part
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
