Skip to main content

Hi all,

 

Refer to the below scenario,

 

Environments/Databases:
Version： IFS Cloud 21R2

 

A customer uses a sampling plan for LOT acceptance.
You take a representative sample from the LOT and read "AcceptanceNo=0" and "RejectionNo=1" when using one or more defects found on inspection.
This method is common in the aerospace and defense industry.

 

<Questions>
Q1:IFS supports "ISO 2859-1-1999 / ISO2859-3-2005" in "Standard" of "Acceptance Sampling Parameters".
Is there a solution to apply the "C=0" rule to "Standard" in "Acceptance Sampling Parameters"?


Q2:Can IFS users create new sampling templates and register them additionally in the IFS system?


<"C=0" rule.>
"C = 0" sampling plan is based on the premise that if zero nonconformities are found during the inspection, the lot is accepted.
It is based on the premise that if one or more non-conformities are found during the inspection, the lot is rejected.
"Another way to define "C = 0" is that AcceptanceNo (ac) is always zero (0).

 

Best regards,

Ushan

 

hi Ushan

a way to always getting Ac=0 would be having inspection level=III and put your AQL=0.01, giving that the Acceptance Quality Limit (AQL) is a statistical measurement of the maximum number (%) of defective goods considered acceptable in a particular sample if you set it as 0.01 you’ll always get ac=0

re Q2, do you mean adding new standards? I’m afraid not, at the moment there are only those two

 

hope this helps!

Ana

Reply


Terms & ConditionsCookie settings