Hi,
we have the IFS 10 and recently found out that most of the lead times of the components are not accurate. There is any way that we can update the component part numbers in a massive load in to the system instead go one by one. We manage around 500 component part numbers.
If it is the supplier leadtime, it can be done on the Supplier for Purchase Part overview using find and replace, but only if they are all going to the same value.
If it is the purchasing leadtime, it can be done on the inventory parts overview, also using find and replace, again limited to changing to a single value at a time.
If you want to set the values from a list where each value is different per part as I suspect is the case, then a migration job is the best solution.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.