Hi everyone,
we have received one requirement and would like to understand the scope of this.
Is there any possible way to conduct preventive maintenance on individual parts(especially on the inventory part ) no necessary if it is connected to any main object and not necessary if it is a serial object.\
thanks in advance.
BT
Best answer by Mayura Wasantha
View original
+15
Hello, the only way to way to conduct preventive maintenance on an on individual part is to make it Maintenance Aware. In that case it in turn creates a serial object reference but Current Position is being set as “In Inventory”.
+15
Hello, the only way to way to conduct preventive maintenance on an on individual part is to make it Maintenance Aware. In that case it in turn creates a serial object reference but Current Position is being set as “In Inventory”.
Check the “Make Maintenance Aware” activity in the below process documentation.
Hi
thank you for the response the above information was really helpful however, is there any such scope for the non-serialized part?
Regards
BT
+15
No, not for my best knowledge.
By the way, what is business case here ?
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.
