hi
Do you know why the total value is not incremented ? the parameter is accumulated ?
I added a new unit measure : numeric
Thanks
Regards
Best answer by EqeRobertK
View originalhi
Do you know why the total value is not incremented ? the parameter is accumulated ?
I added a new unit measure : numeric
Thanks
Regards
Best answer by EqeRobertK
View originalHi
The new reading you enter should be the total.
So the new value is equal or higher than the previous value (only incase of a roll over of the meter, or there is a new meter installed).
So in case you expect 2 stops, you need to enter 2 as the the new value.
If you need more information, you can use the online help text (F1).
Good luck,
Robert
Thanks a lot
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.