Is there any way to auto-complete the QTY to Move field with the quantity from the field Available Qty to Move on the screen below?
Userlevel 6
+13
Because it seems like this is fixed in the latest release. But I found the same behavior in 23R1 as well.
Hope this helps !
Userlevel 6
+13
It seems like this is auto-filled when the part is the Serial Tracked Part only.
Therefore AFAIK your requirement cannot be achieved without a customization.
If this is frequently used, you would be able to save considerable time by automating. So in such situations, in Aurena I have used an extension which supports userscripts such as Tampermonkey/ Greasemoney. But that is a non-standard fix which cannot be recommended :)
+2
I tried to achieve this by changing the attribute in the Qty to Move field in Page Designer but it works differently than I thought. It just displays the quantity from the field that was indicated.
Reply
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.