Hi,
We have created a new site and created inventory parts for this site and set the Planning Method to B. And the IPR parameters were set as below. But when we do the IPR Refresh, we get an error ‘Site not loaded’ Is there some setup that is missing that does not load the part for the new store in IPR? The registry settings for the DP server has onlyLoadSite as empty meaning all sites should be loaded.
What have I missed that gives me this error? Please advice!
+24
Hi Harini,
I had a quick look in the Support system and i don’t see any other cases reporting this error. Unless someone else comes back with a recommendation, I would log this with IFS Support
+4
Try to restart the DP/IPR Server, that should do the trick
/Ingvar
+4
As shown above, Select the “Inventory Part Planning and Replenishment” check box at site level and restart the DP Server again.
Kind regards
Chanaka
Hi Chanaka,
Is it possible to run IPR without demand planner server set up? and is there any documents to help out on the set up.
Regards
Brijesh
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.
